LEGALESE ~~~~~~~~ Copyright (c) 1995 Ilya Zakharevich. All rights reserved. This program is free software; you can redistribute it and/or modify it under the same terms as Perl itself. You should have received a copy of the Perl license along with Perl; see the file README in Perl distribution. You should have received a copy of the GNU General Public License along with Perl; see the file Copying. If not, write to the Free Software Foundation, 675 Mass Ave, Cambridge, MA 02139, USA. You should have received a copy of the Artistic License along with Perl; see the file Artistic. Author of this software makes no claim whatsoever about suitability, reliability, edability, editability or usability of this product, and should not be kept liable for any damage resulting from the use of it. If you can use it, you are in luck, if not, I should not be kept responsible. Keep a handy copy of your backup tape at hand. WHAT ~~~~ This module is intended for low-resolution or high-resolution graphics using gnuplot low-level functions. Documentation is at the start of the .pm file. INSTALL ~~~~~~~ You may need to edit LIBS line in Makefile.PL, and INC and CFLAGS lines in gnuterm/Makefile.PL (as based on the included platform-specific makefiles and READMEs in ./gnuterm directory), but if not, this should work: perl Makefile.PL make make test (Check whether you are satisfied with the result.) make install If you needed some changed, and can automate them, please send patches to the address below. Note that for some term types (such as X11, or PM) additional binaries are needed. They should be available if gnuplot runs on your platform already. AUTHOR BUGS ~~~~~~~~~~~ Ilya Zakharevich ilya@math.ohio-state.edu CHANGES ~~~~~~~ 0.2: Test added. 0.3: Part of gnuplot3.5 distribution included to make it into turnkey installation, tested on OS/2, Solaris. 0.4: list_terms() added; interactive test for different terminals; 0.41: change_term_address(), term_tbl_address() added; 0.5: uses Gnuplot 3.6pre built 340 (with a tiny patch, included); change_term returns 1 on success, 0 on failure; 0.51: Does not need any change to Gnuplot source files. 0.55: Updated to latest Gnuplot.h from PARI 2.0.13 (with do_init => init). setpointsize works now. set_gnuplot_fh() removed, replaced by plot_outfile_set(). Updated to version 3.7. stdfn.c needed too... setpointsize(0.25) instead of pointsize(). GD terminal was coring, since it required calling option before plot.